T: +44 (0)1702 600316

Avocet Aviation Logo

Partnerships

Butterfield Industries

Avocet Aviation is the authorized Butterfield Industries distributor for their complete range of aftermarket products. Keep your aircraft looking clean by preventing the discharge of oil over the nacelle and landing gear. Following are details of the EASA certified kits available for King Air 200, B200 and B200GT models.

 

Butterfield Logo

BI1001-1 Flow Through Anti-Ice Kit

Applicable for installation on King Air 200 & B200. EASA Certified

Replaces the original configuration in which the hot exhaust gas is extracted from the exhaust stacks and ducted down the sides of the intake lip to exit out of the bottom of the cowling.

The Butterfield Industries Flow Through kit changes this by extracting the hot gas from the right side only and then ducting it down the right side, passing all the way through the duct, and coming up the left side of the cowling before exiting out of the left exhaust stack.

BI1011-1 Oil Residue Collection System

Applicable for installation on King Air 200 & B200. EASA Certified

The original configuration drains all garlock seals on the back of the engine directly overboard by way of a gang drain at the bottom of the cowling.

The Butterfield Industries Oil Residue Collection System installs a tank in place of the current gang drain in the cowling. This tank can then be drained as required to stop oil from being discharged over the bottom of the nacelle and landing gear.

BI6001-1 Air / Oil Separator System

Applicable for installation on King Air 200, B200 & B200GT. EASA Certified

Replaces the original configuration in which vented air from the Engine is directed out through a tube in the wheel well and dumped overboard at the rear of the nacelle, just forward of the flap.

The Butterfield Industries Air/Oil Separator is mounted on the firewall and plumbed into the vent line of the engine. The fine mist of oil from the tube is extracted and deposited in the residue tank.

NOTE: To use the Air / Oil Separator, an Oil Residue Collection System must also be installed as the tank will be used to collect oil extracted from the vent tube.

Call us now for pricing, drawings and installation instructions, or for information on other Butterfield Industries products.